My DIY Project 2 and yummy (got pics)

My custom Penis shape gag (you can use it for forced cum, eating, or other things)

Materials needed: a smaller M&M container cling film ape hammer and screwdriver

Here’s how I made it: I placed the screwdriver on the bottom of the tube (not the lid) and hit it with a hammer until the middle popped out. Then I wrapped the opening in cling film to get the width I wanted, securing it all around with tape but leaving the hole open. Next, I took that flat plastic card piece, cut a slot for the gag, measured how far into my mouth it would go, and taped it securely in place. Finally, I attached a strap to the plastic part at the base.

I removed the tape from the lid so it can be opened easily now. When I’m done cumming inside it, I just cover the hole with my finger, add a bit of water, strap it on tight, and enjoy some SB fun.